Add a drill hole below where the boost pads sits

gargomoma / fakeTec_pcb

A low-cost nrf52 device.

35 stars 1 forks source link

Open Nestpebble opened 1 month ago

Nestpebble commented 1 month ago

Hey, could you add a little hole underneath the boost pads, please? It's sort of shown in this drawing: https://discord.com/channels/867578229534359593/1194757507013427250/1272294175194222593

I've also made a footprint in the EasyEDA library that shows it - I'll find a link a bit later on.

lupusworax commented 1 week ago

I would also love to see that happen, please please please! It would make things a lot easier.