with modpoll -h i receive the following help information:
Usage: modpoll [OPTIONS] SERIALPORT|HOST [WRITEVALUES...]
Arguments:
SERIALPORT Serial port when using Modbus ASCII or Modbus RTU protocol
COM1, COM2 ... on Windows
/dev/ttyS0, /dev/ttyS1 ... on Linux
HOST Host name or dotted IP address when using MDBUS/TCP protocol
WRITEVALUES List of values to be written. If none specified (default) modpoll reads data.
General options:
-m ascii Modbus ASCII protocol
-m rtu Modbus RTU protocol (default if SERIALPORT contains \ or COM)
-m tcp MODBUS/TCP protocol (default otherwise)
-m udp MODBUS UDP
-m enc Encapsulated Modbus RTU over TCP
-a # Slave address (1-247 for serial, 0-255 for TCP, 1 is default)
-r # Start reference (1-65536, 100 is default)
-c # Number of values to read (1-125, 1 is default), optional for writing (use -c 1 to force FC5 or FC6)
-t 0 Discrete output (coil) data type
-t 1 Discrete input data type
-t 3 16-bit input register data type
-t 3:hex 16-bit input register data type with hex display
-t 3:int 32-bit integer data type in input register table
-t 3:mod 32-bit module 10000 data type in input register table
-t 3:float 32-bit float data type in input register table
-t 4 16-bit output (holding) register data type (default)
-t 4:hex 16-bit output (holding) register data type with hex display
-t 4:int 32-bit integer data type in output (holding) register table
-t 4:mod 32-bit module 10000 type in output (holding) register table
-t 4:float 32-bit float data type in output (holding) register table
-i Slave operates on big-endian 32-bit integers
-f Slave operates on big-endian 32-bit floats
-e Use Daniel/Enron single register 32-bit mode (implies -i and -f)
-0 First reference is 0 (PDU addressing) instead 1
-1 Poll only once only, otherwise every poll rate interval
-l # Poll rate in ms, (1000 is default)
-o # Time-out in seconds (0.01 - 10.0, 1.0 s is default)
Options for MODBUS/TCP, UDP and RTU over TCP:
-p # IP protocol port number (502 is default)
Options for Modbus ASCII and Modbus RTU:
-b # Baudrate (e.g. 9600, 19200, ...) (19200 is default)
-d # Databits (7 or 8 for ASCII protocol, 8 for RTU)
-s # Stopbits (1 or 2, 1 is default)
-p none No parity
-p even Even parity (default)
-p odd Odd parity
-4 # RS-485 mode, RTS on while transmitting and another # ms after
I use a modpoll program on Windows.
with modpoll -h i receive the following help information:
if i use the following command:
modpoll.exe -l 5000 -t 4 -p 502 -m enc -a 247 -r 769 -c 124 192.168.178.88
i receive data from the modbus device like following
can someone explain me how the config file of modpoll must look so that I get data?