I set up and installed software. Add the batteries and full charge. Then i left my pi to discharge and then plug it to recharge it. My pi is showing full charge led status. But, if i boot my pi and run x728bat.py it is showing wrong %. In my case, since it was empty, it is showing 2% charging and voltage 4.12v.
I set up and installed software. Add the batteries and full charge. Then i left my pi to discharge and then plug it to recharge it. My pi is showing full charge led status. But, if i boot my pi and run x728bat.py it is showing wrong %. In my case, since it was empty, it is showing 2% charging and voltage 4.12v.
How can i fix this?
Also, is it possible to charge until 90%?