search

geerlingguy / pi-camera

A Raspberry Pi Camera
MIT License
108 stars 10 forks source link

Case design improvements - bottom plate #1

Open geerlingguy opened 1 year ago

geerlingguy commented 1 year ago

Two things I think would finish off the bottom plate a little better:

  1. Thickening the bottom plate a bit (and/or just beefing up an area near the center of mass) so it can accept a 1/4"-20 8mm deep threaded heat set insert.
  2. Along with the thickening, recess the two screw holes for holding the bottom plate to the upper case, that way the bottom can sit flat on a surface with no wobble.