v1.0 issues

[gkasprow]

38M-49SMD-SR -> 8M-49SMD-SR

[gkasprow]

• [ ] fix footprint for R-78K12-2.0 and
• [ ] IRM-30-15

[gkasprow]

• [ ] move J7, J4, J8 to the edge

[gkasprow]

• [ ] add lead-acid battery fuse and reverse protection diode

[gkasprow]

• [ ] integrate Lilygo with main PCB

[gkasprow]

• [ ] use pnp switch for battery charger due to MCP34063 dropout or use IRM30-24. For the moment buck gives only 13.3V

[gkasprow]

• [ ] add ID jumper for dual-battery operation

[gkasprow]

• [ ] change power in to vertical RA

[gkasprow]

• [ ] add delay to 5V rail, battery must get the voltage first!

[gkasprow]

• [ ] removal of D6 and shorting of IGN relay does not help; hover when I first connect 12V to IGN and turn on the rest it works. It looks like IGN must arrive immediately.

[gkasprow]

• [ ] adding 5V control of IGN relay does not help; controlling of IGN relay with 10k from 12V doesn't help neither; delaying RST of CPU helps

[gkasprow]

• [ ] add 33uF in parallel with RST switch to solve the issue. It looks like CPU talking too early to the BMS hangs CAN

[gkasprow]

• [ ] move back the RJ45 connectors at least 1cm

[gkasprow]

• [ ] add LCD connector (debug info)

[gkasprow]

• [ ] move status LEDS to the upper board area
• [ ] use lower cost enclosure

[gkasprow]

• [ ] add jumper or other switch that disconnects 33uF cap from reset pin - the USB programmer cannot discharge the cap quickly