glangsto
commented
2 years ago Hi Dave,
Sorry about any confusion.
Now I’m wondering what happened. I think someone might have asked for frequencies instead of velocities. It should not be too hard to make the output match the requested plot type.
Did you want all velocities in the spectrum or only the velocities plotted? The difference between the output files and the plots has been a little bit of a documentation headache.
If frequencies, then all data were written+plotted. If velocities, only the selected velocities were plotted (and written?).
Best regards
Glen
I’ve got lots of meetings, so this may take a day or two.
Glen I Langston, Ph. D. Galactic Astronomy Program Director National Science Foundation 304-456-3032
On May 25, 2022, at 1:45 PM, dave290 @.***> wrote:
This email originated from outside of the National Science Foundation. Do not click links or open attachments unless you recognize the sender and know the content is safe.
Hello! Up until recently, the T program would write velocities (instead of frequencies) to the .kel file, when the -V and -W flags were used. I updated the analyze package a few months ago and just noticed that instead of velocities, frequencies (in Hz) are written instead, even though the labels within the .kel file say 'velocity.' I did a git pull this morning and see the same issue.
For example, you should see it if you run T with the data files that are provided in the complimentary data set (18-11-01T...18-11-02T) using the command below: T -B -L -200 -H +200 -V -W 600 and other related commands, like: T -W 600
When the .kel file is written, the data lists frequencies instead of velocities (see example below):
N Velocity Intensity
(m/sec) (Kelvins)
0000 1419981933 -0.4236
Note that T does, in fact, plot the velocity range correctly. I dove into the code, but it's not obvious to me what to modify. Could you please take a look? Thank you!
— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.
dave290
Hello! Up until recently, the T program would write velocities (instead of frequencies) to the .kel file, when the -V and -W flags were used. I updated the analyze package a few months ago and just noticed that instead of velocities, frequencies (in Hz) are written instead, even though the labels within the .kel file say 'velocity.' I did a git pull this morning and see the same issue.
For example, you should see it if you run T with the data files that are provided in the complimentary data set (18-11-01T...18-11-02T) using the command below: T -B -L -200 -H +200 -V -W 600 and other related commands, like: T -W 600
When the .kel file is written, the data lists frequencies instead of velocities (see example below):
N Velocity Intensity
(m/sec) (Kelvins)
0000 1419981933 -0.4236
Note that T does, in fact, plot the velocity range correctly. I dove into the code, but it's not obvious to me what to modify. Could you please take a look? Thank you!