jaysuk
commented
4 years ago No, there isn't. The only way that works is to follow the instructions on the wiki
On Mon, 24 Aug 2020, 18:57 Drzet, notifications@github.com wrote:
After trying unsuccessfully to make ESP2866 module work I realised that the pins mentioned in config : 0.28, 1.30 and 1.31 are located over in the expansion section. The middle pins of 8pin WiFi connector, according to official pinout diagram are "N/C" which as I understand stands for "not connected" ?
Please correct me if I wrong. Otherwise, is there a way to reassign these pins to utilise WiFi connector?
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/gloomyandy/RepRapFirmware/issues/31, or unsubscribe https://github.com/notifications/unsubscribe-auth/AATUSBVSN7YD5NFWQJHHDA3SCKSZNANCNFSM4QJYJF4Q .
After trying unsuccessfully to make ESP2866 module work I realised that the pins mentioned in config : 0.28, 1.30 and 1.31 are located over in the expansion section. The middle pins of 8pin WiFi connector, according to official pinout diagram are "N/C" which as I understand stands for "not connected" ? https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/blob/master/BTT%20SKR%20V1.4/Hardware/BTT%20SKR%20V1.4PIN.pdf
Please correct me if I wrong. Otherwise, is there a way to reassign these pins to utilise WiFi connector?