Pairing does not work using a different zwave usb stick

[alie2n]

I followed all steps to install HACS and duofern for hacs. I was able to set the network code and select my z-wave stick (Z-Wave USB Stick (ZMEEUZB1); usb vendor id: 0658:0200). No error message was shown, but I am unable to pair hass.io to the "RolloTron Comfort DuoFern 1800-UW".

I followed these steps:

• Radmacher
• • Menu -> 9 -> 9 -> 1 -> On (blinking)
• Home Assistant
• • Development tools -> services -> duofern.start_paring (payload: timeout:60) In the logfile I see: 2021-02-06 03:11:16 WARNING (SyncWorker_5) [custom_components.duofern] start pairing but I do not see any devices and the device count on the 1800-uw does not increase.

[gluap]

Hi @alie2n, zwave and duofern are different protocols and require different sticks. The menu offers all serial devices and relies on the user to select a duofern (not a zwave) stick.

Are you sure that there were no error messages in the log? I'd expect the initialization to fail when run against non-duofern hardware, that should show up in the log.

edit to add: Rademacher offers both duofern and zwave devices, but to my best knowledge each protocol has a dedicated usb stick.

[gluap]

no activity for a long time, closing. Feel free to reopen.