Let me start off that I'm very new at using the program and software. Love the software but have two issues that I would very much be appreciated if y'all can help me. I have a Wainlux L3 engraver, just got it delivered and setup. My problem is it will go to home in the upper right hand corner then immediately go to the lower left corner. Also, the work area is way off and I constantly get "out of range" errors. How do I make home upper right corner and how do I correct the work area to be correct? Thank you.
Let me start off that I'm very new at using the program and software. Love the software but have two issues that I would very much be appreciated if y'all can help me. I have a Wainlux L3 engraver, just got it delivered and setup. My problem is it will go to home in the upper right hand corner then immediately go to the lower left corner. Also, the work area is way off and I constantly get "out of range" errors. How do I make home upper right corner and how do I correct the work area to be correct? Thank you.