search

gnea / grbl

An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino
https://github.com/gnea/grbl/wiki
Other
3.98k stars 1.59k forks source link

GRBL changes saved parameters #1233

Open SebastianKusykIFJ opened 7 months ago

SebastianKusykIFJ commented 7 months ago

Sometimes GRBL parameters change, although I haven't done it. I.e. today my X motor couldn't move - it occured that X resolutions was set to 0 steps/mm. After setting it to 100 again, it works. Sometimes parameters were much more destroyed - there were completely random values in many fields.

breiler commented 7 months ago

Sounds like your Arduino eeprom is either broken or that you have upgraded the firmware and did not reset the eeprom settings. Try and run $RST=$