Open ARCHITAIT opened 6 years ago
I have a laser with a similar controller. "+" and "-" pins are for 12V supply. "PWM/TTL" should be connected to D11 on the Arduino. You can simply solder to the corresponding pad on the back of the board.
Thanks !
Sent from my iPhone
On 15 Jul 2018, at 12:49 am, Artem Godlevskyi notifications@github.com<mailto:notifications@github.com> wrote:
I have a laser with a similar controller. "+" and "-" pins are for 12V supply. "PWM/TTL" should be connected to D11. You can simply solder to the corresponding pad on the back of the board.
— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHubhttps://github.com/gnea/grbl/issues/448#issuecomment-405035560, or mute the threadhttps://github.com/notifications/unsubscribe-auth/AlrOvOLhwLkJ33uasa3bs0r9jMoVB_oQks5uGiEUgaJpZM4UH0RE.
Hello All, I need your help with something I am trying to upgrade my laser module on a Chinese CNC laser engraver 3000mw to a 15 w laser module
what i am facing here is that the new laser has a 3 pin ( + , - , PWM/TTL ) and the board on my CNC has only 2 pin (+ , - )
is there a way to connect the Laser to this Board ?
i added to thix dropbox link a photo of my 15w laser driver https://www.dropbox.com/s/wxow68moblyfwma/15W%20driver.jpg?dl=0
and this is my CNC controller photo https://www.dropbox.com/s/l7b4kcbpix4bgpq/CNC.jpg?dl=0
please note that i am not an expert in electronics, i know few things about PWM and building basic circuits .
Thanks !