search

gneu42 / Triple-Decky

New triple deck filament block for ERCF V1 and Sturdy Bunny
99 stars 13 forks source link

C9 Magnet issues ECAS-magnet STL and FB-Magnet STl too small for standard 10mm magnets #5

Open Urminme opened 1 month ago

Urminme commented 1 month ago

Ive tried printing these several times but the holes on the STL measure around 9.5mm and the magnets are 10mm exactly so they just dont fit and if forced break the plastic, Ive tried printing with less walls but even then its just too small, Do you have a newer file that is the correct one or specific settings for these pieces

gneu42 commented 1 month ago

Yes, your are right. I made them so my magnets fits. My 10mm magnet are 9.5mm OD. I suppose that depending of the magnet manufacturer, it will change a bit. I will make new part for 10mm.

gneu42 commented 1 month ago

New files are uploaded? Was tested with 10mm drill bit, because my magnets are 9.6mm OD

Urminme commented 1 month ago

Thank you very much for the update that fits perfectly!

gneu42 commented 1 month ago

Your welcome.