Thanks again for a great integration, I have now been using this a few months and it is working without issues for me! I now have much better control of my heatpump, temperature and power management.
One thing I was wondering if the heatpump is sending out temperature readings with two decimals? Is it possible to increase decimal readings in HA to 0.00?
The reason why I am asking is that my heatpump is not good at keeping the setpoint temperature, sometimes drop several degrees below setpoint before starting to heat again. So I made an automation that increase the setpoint temperature with 0.5degrees for every temperature dropping 0.1 below setpoint to chase the pump to start heating again. This is working quite good and the temperature control is now much better. But 0.1 degree resolution is quite high and makes the setpoint a little bit jumpy. Therefore I could make even better control if I could regulate setpoint with 0.01 precision rather than 0.1.
Thanks again for a great integration, I have now been using this a few months and it is working without issues for me! I now have much better control of my heatpump, temperature and power management.
One thing I was wondering if the heatpump is sending out temperature readings with two decimals? Is it possible to increase decimal readings in HA to 0.00?
The reason why I am asking is that my heatpump is not good at keeping the setpoint temperature, sometimes drop several degrees below setpoint before starting to heat again. So I made an automation that increase the setpoint temperature with 0.5degrees for every temperature dropping 0.1 below setpoint to chase the pump to start heating again. This is working quite good and the temperature control is now much better. But 0.1 degree resolution is quite high and makes the setpoint a little bit jumpy. Therefore I could make even better control if I could regulate setpoint with 0.01 precision rather than 0.1.