search

googlecreativelab / open-nsynth-super

Open NSynth Super is an experimental physical interface for the NSynth algorithm
Apache License 2.0
2.42k stars 270 forks source link

Upgrading hardware to 1.2 - wire encoder switches #83

Open TTRCmedia opened 4 years ago

TTRCmedia commented 4 years ago

Hello! I just finished my build, using the original PCB layout. As I did not get the encoders without momentary switch, I use encoders with switch. but I did not cut off the unnecessary legs, I just bent them upwards so they are lying on top of the PCB. If I read the current version of the schematics correctly, the switches for using the "new" feature to store patches are connected between ground and GPIO pins. So would it be possible to use some thin wire to connect one pin of each encoder to ground and the other one to the correct GPIO pin, or are there other changes to the schematics to make this feature work? Regards, Danyel

Jonny0815 commented 4 years ago

having the same question

nervousapps commented 4 years ago

Just wire the encoder switch pins to the corresponding GPIO pins and upgrade the firmware. It works great ! No other changes on the schematics than that for this feature.

TTRCmedia commented 4 years ago

Great! I´ll give it a try :)