Cable management

[polemidis]

• [ ] Add to the CAD the Cable chains (issue #25 )

• [ ] Print cable chains and test CAD model (issue #25 )

• [ ] Design and add to the CAD the support for the Y axis (the long one) cable chain. Has to be towards the X Rail, as if it extends to far behind the drag chain can be caught to the end of the Y rail

• [ ] Add a plate where the breakoutbox lays (see below) but extend it towards the outside of the X axis, so the Y Axis cable chain can attach to underneath

• [ ] CAD is missing the box where the cnc breakout board goes. It is at one end of the X axis, behind the back (2nd) rail. The cable chain lays on top of the X Axis back rail

• [ ] Replace in CAD the top "threaded rod plate nema 23" (top plate on Z azis) with a longer one so the drag chain for the X axis can attach there.

See an example of chain and cable management retrieved from thingiverse

[jurra]

[jurra]

B=50mm width, 18mm height is the ones on the link i believe. Can you open it? The top where you measure the A should be removable so we frst put the wire in, and the close it. It will help 3D printing by a lot since so support is needed.