mossmann
commented
4 days ago Our firmware does not configure the behavior of INTR. INTR being pulled low does not indicate an error.
Open otpisani opened 4 days ago
mossmann
commented
4 days ago Our firmware does not configure the behavior of INTR. INTR being pulled low does not indicate an error.
Have you read the HackRF documentation?
yes
What outcome were you hoping for?
Check point measurement P15 depends from pin 3 (INTR) U19 SIS5351C and resistor R104,that point need to gave around 3.25V, but I don't have any voltage, what other elements or chipset close to U19 can cause that hardware error
What outcome actually happened?
P15 don't have any voltage
What operating systems are you seeing the problem on?
linux
What is the output of
hackrf_info?hackrf_info version: 2024.02.1 libhackrf version: 2024.02.1 (0.9) Found HackRF Index: 0 Serial number: 0000000000000000909862dc262695cf Board ID Number: 2 (HackRF One) Firmware Version: v2.0.1 (API:1.08) Part ID Number: 0xa000cb3c 0x00744f58 Hardware Revision: older than r6 Hardware supported by installed firmware: HackRF One
Are you using any third-party software?
GNU Radio
Are you using any third-party hardware?
firmware from portapack