Open clicktoselect opened 1 year ago
Hi @clicktoselect , thanks for reporting this, I was actually wondering how Prusa ship things regarding this. Did you receive the metal bearing clips with the carriage? Those in green in this page: https://help.prusa3d.com/guide/2a-y-axis-assembly_406654#407495
It came by itself only, no bearing clips included sadly
Looks like there is an issue with Prusa, they should have send you the bearing clips. Bearing clips have been introduced with MK3S+ which means if you are on MK3S you don't have those (it was U bolt at that time) and so the carriage they sell isn't compatible with MK3S. Might be good to talk to the support.
MK3S kit bed bearings assembly (steps 24 to 27): https://help.prusa3d.com/guide/2-y-axis-assembly_25488#26528 MK3(S) to MK3S+ upgrade (steps 4 to 7): https://help.prusa3d.com/guide/5-y-axis-upgrade_194395#194732
On MK4 they have added bearing pads and plastic pads, I would ask the support if you could get those too. See the step 12 here: https://help.prusa3d.com/guide/7-y-carriage-heatbed-assembly_438310#438578
I am not able to update those parts at the moment but I will update the assembly guide to explain that the new carriage should be used with the bearing clips.
Please let me know how it goes with the support :)
Thanks for your help Greg. I'll get in contact with Prusa support and see if they can offer me any of the new clips and pads. Thanks again!
Good luck 👍
Just to follow up on this. I noticed the other day that the MK3s+ assembly manual now shows the new carriage, and does not actually require those pads that the mk4 has (https://help.prusa3d.com/guide/2a-y-axis-assembly_406654#408670)
In this case, it should be fine to just use the prusa bearing clips for the bear frame, instead of using the specific bear y bearing clips?
I think the Bear version makes the Yvaxis a bit more silent. But both are fine.
I had to get a new carriage for my MK3s and Prusa only sell the mk4 one now. The bearing holders aren’t quite big/deep enough to actually make contact with the carriage once the screws are tightened so they are sort of floating there. Has anyone else had this issue or found a solution? I know it’s a bit of a weird issue having mk4 carriage on mk3