Closed bwcarty closed 4 years ago
Good point! Thanks will be improved ;-)
Would be good to clarify where the washers go around the Z motors as well.
This will be addressed in 2.1 release.
Fixed with new assembly guide: https://guides.bear-lab.com/c/Frame
It has been a long time since my last Prusa build, and I forgot that the left z motor has a shorter cable than the right z motor. I ended up having them reversed until it was time to connect the cables, and I ended up having to disassemble a lot of parts to get the motors in the right place.
A simple "Caution: Be sure the z motor with the shorter cable is on the left side. The z motor with the longer cable should be on the right" would save others the same grief. This could be added to step 12.1 and or fig 12.1.