search

guysoft / OctoPi

Scripts to build OctoPi, a Raspberry PI distro for controlling 3D printers over the web
GNU General Public License v3.0
2.49k stars 369 forks source link

0.17.0 haproxy issue #699

Closed AaronAnz closed 2 years ago

AaronAnz commented 3 years ago

What were you doing?

  1. Install 2018-11-13-octopi-stretch-lite-0.17.0 or greater
  2. Configure network
  3. visit ip address in web browser

What did you expect to happen?

to see web panel

What happened instead?

refused to connect

Did the same happen when running OctoPrint in safe mode?

not sure

Version of OctoPi

0.17.0 or greater

I have a raspberry pi 3B+ and it is unable to work out of the box. I know how to configure networking on the device and verified it was running. HAProxy is not running on its own and will not start at all. I had to install 0.16.0 and it worked flawlessly.

guysoft commented 2 years ago

Thanks for reporting the issue was resolved :)

AaronAnz commented 2 years ago

It was never resolved. I don't even use octopi anymore. Was just going through old issues I had open on various libraries and closed it since it was 2 years old and no one even responded.

guysoft commented 2 years ago

Well its a little late to debug it now, the debug otuput from haproxy would have helped to understand what is going on, it might not have even been HAProxy but OctoPrint reporting something.

AaronAnz commented 2 years ago

It's not like anyone ever even responded requesting more information. It was a fresh install at the time and just straight up broken. You clearly didn't care about it.

guysoft commented 2 years ago

Sorry dude, I really go this as volunteer work and sometimes I really don't have time to fix stuff. I do what I can.