Hello Folks,
I'm still trying to use extended feature of the Mopi1 I have buy some weeks ago. But I always get a "Communication protocol error on read word" as answer when trying to use "mopi" or "mopicli" command. The hardware function seems to be all right.
Only "sudo mopi -d" is working. I've read no error message during installation. I've checked the I2C and I found BMC2835
I've tried with 2 different RPi zero and an old RPi B. I've tried to follow #109 and #110 and #828 questions but I did not found the solution.
Indeed, I do not understand updated i2c0_bcm2708 firmware could be found. i cannot understand what the combined parameter actually means. The discussion #828 is a bit confusing to me. I cannot grasp what the solution is/was.
I added the following line into /boot/config.txt, then reboot
dtoverlay=i2ci_bcm2708,dtbo
I tested the result with the following command
pi@raspberrypi:~ $ mopicli -v1
mopicli. Communications protocol error on read word.
pi@raspberrypi:~
In order to take the exact version installed I entered fowolowing command
pi@raspberrypi:~ $ cat /sys/module/i2c_bcm2708/srcversion
0C1F4F8690E98B7CEAABAE5
pi@raspberrypi:~ $ uname -a
Linux raspberrypi 4.19.46+ #1231 Mon Jun 3 17:28:02 BST 2019 armv6l GNU/Linux
Hello Folks, I'm still trying to use extended feature of the Mopi1 I have buy some weeks ago. But I always get a "Communication protocol error on read word" as answer when trying to use "mopi" or "mopicli" command. The hardware function seems to be all right. Only "sudo mopi -d" is working. I've read no error message during installation. I've checked the I2C and I found BMC2835 I've tried with 2 different RPi zero and an old RPi B. I've tried to follow #109 and #110 and #828 questions but I did not found the solution.
Indeed, I do not understand updated i2c0_bcm2708 firmware could be found. i cannot understand what the combined parameter actually means. The discussion #828 is a bit confusing to me. I cannot grasp what the solution is/was.
I added the following line into /boot/config.txt, then reboot
dtoverlay=i2ci_bcm2708,dtbo
I tested the result with the following command
In order to take the exact version installed I entered fowolowing command
Thanks in advance for any help. Marc