Updated the cw2_umbilical_pg7 part to have a PG7 threaded hole, to match your "v2_a_drive_pg7_umbilical.stl" part.
I made this change because the holes in the original "cw2_umbilical_pg7.stl" and "v2_a_drive_pg7_umbilical.stl" are not the same, despite the "pg7" suffix in the file names.
The threaded hole on the cw2_umbilical_pg7.stl part is smaller than the threaded hole on the cw2_umbilical_pg7.stl by about 1 mm.
I was able to easily thread both my cnlinko 4-pin connector and my PG7 cable gland into the v2_a_drive_pg7_umbilical.stl part, but no luck with the cw2_umbilical_pg7.stl part.
Updated the cw2_umbilical_pg7 part to have a PG7 threaded hole, to match your "v2_a_drive_pg7_umbilical.stl" part.
I made this change because the holes in the original "cw2_umbilical_pg7.stl" and "v2_a_drive_pg7_umbilical.stl" are not the same, despite the "pg7" suffix in the file names.
The threaded hole on the cw2_umbilical_pg7.stl part is smaller than the threaded hole on the cw2_umbilical_pg7.stl by about 1 mm.
I was able to easily thread both my cnlinko 4-pin connector and my PG7 cable gland into the v2_a_drive_pg7_umbilical.stl part, but no luck with the cw2_umbilical_pg7.stl part.