MY MISTAKE - problem caused by slight movement of camera
Is there a problem with changing the mask in this version of the software.
I am trying to change the masked area for a camera pointing into the garden to reduce false positives due to wind blowing bushes.
I make the changes but some masked cells switch at to unmasked.
The procedure I am following is:
Edit Mask > Save Changes > Apply the changes > then when I look at the masked areas they are not all as I saved them.
I would try the procedure in an alternative sequence of steps Edit Mask > Apply Changes > then save but the Save option is not available after the Apply.
I have never had a problem before this latest version and I am even beginning to wonder if it is because the currently strong wind is causing some interference
MY MISTAKE - problem caused by slight movement of camera Is there a problem with changing the mask in this version of the software. I am trying to change the masked area for a camera pointing into the garden to reduce false positives due to wind blowing bushes. I make the changes but some masked cells switch at to unmasked. The procedure I am following is: Edit Mask > Save Changes > Apply the changes > then when I look at the masked areas they are not all as I saved them. I would try the procedure in an alternative sequence of steps Edit Mask > Apply Changes > then save but the Save option is not available after the Apply. I have never had a problem before this latest version and I am even beginning to wonder if it is because the currently strong wind is causing some interference