heidelberg-makerspace / dai-makerspace-do-something

Issue tracker for tasks you could do in the DAI Makerspace
5 stars 0 forks source link

Mount electronics to wall #107

Open emka opened 7 years ago

emka commented 7 years ago

Put electronics in a nice case (e.g. laser-cut acrylic) and screw it to the wooden wall. Keep in mind where the cables will go.

MichelDC commented 7 years ago

Not the final / best / nicest solution, but a bit cleaner and the milling dust does not get onto the electronics anymore. I have not checked if the Arduino actually gets warm. If yes, I would need to add some ventilation slits.

arduinobox1 arduinobox2

emka commented 7 years ago

Looks great and much cleaner!

Regarding the air flow: Depending on the feed rate, the stepper motor drivers could run hot. If you are experiencing lost steps, resulting in incorrect movements, that will probably be the cause. There are also no heatsinks on the drivers yet.