search

hoarfw / air-mouse

Automatically exported from code.google.com/p/air-mouse
0 stars 0 forks source link

Need Accelerometer PCB #3

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
Sagar, can we make another accelerometer PCB. I would like to be involved. 

We need a few more for redundancy, at DDS. We can get extra Arduino boards
from Keyur if this fails. But We will need more accelerometer boards.

Manav

Original issue reported on code.google.com by manavkataria on 27 May 2009 at 11:08

GoogleCodeExporter commented 9 years ago 
Sagar, please post your updates here. And change the issue 'Status' to 'Fixed' 
when
you are done with the PCB. I'll get to know!
---
Check whether Sagar is getting this mail or not?

Original comment by manavkataria on 1 Jun 2009 at 9:19

GoogleCodeExporter commented 9 years ago 
Sagar, I tested the connector alignment on the Arduino, as you suggested. 

On one side it seems to be aligned with a one-pin gap.
On another side, it does NOT align. The gap is lesser than a single-pin width :(

It think we would have to go for a Shield PCB.

Original comment by manavkataria on 23 Jul 2009 at 6:42

GoogleCodeExporter commented 9 years ago 
     I have made a prototype board so that the entire assembly can be mounted on the
same board.
     The attached file contains the .brd file which can be opened using the Eagle
software.Contact me whenever a printout is being taken...I can assist you 
better.

Original comment by sagarbho...@gmail.com on 28 Jul 2009 at 11:21

Attachments:

GoogleCodeExporter commented 9 years ago 
the updated PCB's up.....
kindly take a Print of the same....

Original comment by sagarbho...@gmail.com on 29 Jul 2009 at 3:43

Attachments:

GoogleCodeExporter commented 9 years ago 
Sagar, Can you please check with Prof PC Pandey or your Satellite team why does 
our 
air-mouse misbehave (high noise) when mounting a PCB on Arduino?

Original comment by manavkataria on 4 Sep 2009 at 3:13