I recreated the feature I deleted in #245. This new feature has the “Use a number series for primary key value” option checked, and the Setup feature card now shows a field for setting the number series to use.
However, the field is read only; I cannot edit it to configure the number series, even when in edit mode on the setup page. (1st screenshot below).
I have not enabled the “Read only” option on the field for the setup card (2nd screenshot below).
I am running as SUPER user, and an “Effective Permissions” check confirms I have full access to the table and table data for that page.
I recreated the feature I deleted in #245. This new feature has the “Use a number series for primary key value” option checked, and the Setup feature card now shows a field for setting the number series to use.
However, the field is read only; I cannot edit it to configure the number series, even when in edit mode on the setup page. (1st screenshot below).
Using SOD 9.0.0.314 / 22.2.56969.57282