Micro source big issue in r1031

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Just installed r1031 over r1027, without any changes to its settings.
2. Mic source has always been set to 'Default'. Not anymore. I can only be 
heard on the phone's earpiece if I set the Mic source to 'Mic'.
3. No bluetooth headset support just by turning on the BT headset anymore. In 
'Default' mode, voice is routed to the bluetooth SCO connection only if CSS's 
process is killed and re-launched, for it to recognize the active BT link at 
init time.

What is the expected output? What do you see instead?
Microphone source should work in 'Default' mode, as it has always been, thus 
dinamically routing the voice path to the correct channel.

What version of the product are you using? On what operating system?
r1031 (trunk) running on a Motorla Defy flashed with walter79's MS2Ginger 1.0.

Please provide any additional information below.
I suppose if mic source 'Default' issue is fixed, voice path would flow through 
either the phone's earpice and built-in microphoneb, or bluetooth SOC 
communication (just by turning the BT heaset on, as always).

Original issue reported on code.google.com by casou...@gmail.com on 26 Sep 2011 at 4:22

[GoogleCodeExporter]

This is getting somewhat funny. After killing and relaunching CSS with the BT 
connection to the headset established, sound is now being picked from the 
headset's mic, but played on the phone's speakerphone!

Original comment by casou...@gmail.com on 26 Sep 2011 at 3:39

[GoogleCodeExporter]

This issue was closed by revision r1033.

Original comment by r3gis...@gmail.com on 29 Sep 2011 at 8:25

• Changed state: Fixed