speeds (or thicknesses, volume of material, etc...) seem to be random rather than in a gradient. as a result it is difficult to read what is happening in a slice.
could you make it in a gradient instead, for example HSV based (hue saturation value) ?
it will make it easier to see at a glance what speed (...etc..) the printing is going at.
Hello there ! thanks for the good job on http://gcode.ws !
speeds (or thicknesses, volume of material, etc...) seem to be random rather than in a gradient. as a result it is difficult to read what is happening in a slice.
could you make it in a gradient instead, for example HSV based (hue saturation value) ? it will make it easier to see at a glance what speed (...etc..) the printing is going at.
thanks again !