I recently began using the tool to calibrate the settings for my new 0.1mm nozzle with PLA.
Due to the low nozzle diameter, and the low temperature required to prevent stringing (180c), I require the ability to start at 0.1mm3/sec with 0.1mm3/sec increments.
The web app currently rejects all Start Flows below 1.0.
I recently began using the tool to calibrate the settings for my new 0.1mm nozzle with PLA. Due to the low nozzle diameter, and the low temperature required to prevent stringing (180c), I require the ability to start at 0.1mm3/sec with 0.1mm3/sec increments.
The web app currently rejects all Start Flows below 1.0.