Arvycka
commented
6 years ago That would be very useful - especially for a fixed wing where iNav is trying to break servos and linkages on every reboot. (What is that servo twitch about anyway?)
Open csurf opened 6 years ago
Arvycka
commented
6 years ago That would be very useful - especially for a fixed wing where iNav is trying to break servos and linkages on every reboot. (What is that servo twitch about anyway?)
marianomd
commented
5 years ago Yes please. By itself, current sensor calibration is a PITA. Requires lots of iterations. This should be copied from betaflight configurator, so it's a little easier. Also, showing the amperage in the motors tab is needed.
Currently, the current sensor settings are located within Configurator's general "Configuraton" settings tab, which has a 'save & reboot' button in order to save the settings. This causes the current calibration process to be a slower, more tedious process. IOW, if you're trying to play with the offset & scaling values for the current sensor, you're forced to wait for the board to reboot before seeing the results of the changes.
Can we please consider moving the current sensor settings to a different tab where we can save & apply changes to the current settings instantaneously without having to go through a reboot? This way, we can see the results of the changes in realtime. It could be via a simple 'save' button (like in the 'Modes' tab).
Perhaps we could have a separate 'Analog' tab or something where we could configure & calibrate these types of sensors?
(FYI, we should probably also do this for battery settings, no need for reboot)
Does this sound acceptable?