correcting material parameters

[Mick3Lozzo]

Correcting parameters according to

See also this page and this datasheet.

[fiorisi]

Thanks @Mick3Lozzo. Few points:

• why here there is written ergal?
• I would provide also a material description. See here
• I think that we can't manufacture sheetmetal parts with this material. Where did you take the PTC_INITIAL_BEND_Y_FACTOR value? The same for PTC_BEND_TABLE
• Do you have a source for the value of the parameter PTC_MASS_DENSITY ?

[Mick3Lozzo]

Thanks @Mick3Lozzo. Few points:

• Do you have a source for the value of the parameter PTC_MASS_DENSITY ?

It's in the datasheet @fiorisi.

[Mick3Lozzo]

For NdFeB magnets, the physical properties are different than for 100% Neodymium.

See this link.

[fiorisi]

Thanks @Mick3Lozzo. Few points:

• Do you have a source for the value of the parameter PTC_MASS_DENSITY ?

It's in the datasheet @fiorisi.

7.5 Kg for cube meter? Seems low, in the file you actually set it to 7.5 g / cm^3

[Mick3Lozzo]

7.5 Kg for cube meter? Seems low, in the file you actually set it to 7.5 g / cm^3

In the other table, I saw 7.5 g/cc. I suppose "cc" is cm^3 @fiorisi.

[Mick3Lozzo]

@fiorisi for all the materials We have Initial Bend Y-Factor = 0.5

We can consider it as a sort of default value?

See also Matweb.

[Mick3Lozzo]

Done @fiorisi

[fiorisi]

@Mick3Lozzo you can not merge a PR if has not been approved. Please next time when changes are requested, make the changes and request another review.