search

igiannakas / mmWave-Presense-Sensor-D1-Mini-DFRobot-

Room presence detection using mmWave radar (DFRobot SEN0395), D1 Mini ESP-8266 and ESPHome for HomeAssistant
116 stars 9 forks source link

A esp32 d1 mini is perfect #1

Closed stofakiller closed 1 year ago

stofakiller commented 1 year ago

Hi, i tried a esp32 d1 mini, with 2 rows of pins on either side. and i can connect the sensor directly. pin 21/22 for rx/tx, 16/17 for the IO1 (not used) and IO2 from the sensor and vcc and gnd... esp32

igiannakas commented 1 year ago

Fantastic! I will need to try it out for sure! Unfortunately the case won’t work as I think it’s slightly larger but a bit of scaling of the stl in cura should fix that.

Ramblurr commented 1 year ago

@igiannakas Would you be willing to help scale the STL to fit the esp32 d1 mini? I'm not very talented with CAD unfortunately.

My calipers tell me that the ESP32 d1 mini PCB is 31.78 mm wide x 39.09mm long. If you measure the length from one end of the PCB to the other and include the micro usb socket then the length is about 39.9mm

igiannakas commented 1 year ago

@igiannakas Would you be willing to help scale the STL to fit the esp32 d1 mini? I'm not very talented with CAD unfortunately.

My calipers tell me that the ESP32 d1 mini PCB is 31.78 mm wide x 39.09mm long. If you measure the length from one end of the PCB to the other and include the micro usb socket then the length is about 39.9mm

Should be able to scale it up to the size you want in your 3D printer slicer? No need for CAD to bump up its dimensions?

harphere commented 1 year ago

@stofakiller , did you happen to print a case to fit the ESP32 version?

stofakiller commented 1 year ago

Hi,Sorry not Venlig hilsen/Best Regards,Jan LarsenDen 20. jan. 2023 kl. 00.50 skrev nickelnine @.***>: @stofakiller , did you happen to print a case to fit the ESP32 version?

—Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you were mentioned.Message ID: @.***>