search

image-et-son / p600fw

GliGli based Prophet 600 firmware upgrade
10 stars 4 forks source link

UI Bugs with target alpha 13.3 #103

Closed image-et-son closed 2 years ago

image-et-son commented 2 years ago

1) When started in preset mode the loaded preset directly received the display dot as if the sound was edited --> FIXED

2) In preset mode changing the arp/seq speed shows up as a dot in the diplay as if the preset was changed (which it is not, since the speed is not stored in the patch) --> FiXED

3) In preset patch mode: when the last pot to be touched is the data pot pressing From Tape will immediately apply the current data pot value and load that patch --> FIXED

4) Sometimes when entering preset mode that prestet changed dot appears. There is no apparent pattern to this.

matrix12x commented 2 years ago

Compiled 7079a0e On boot into preset mode I'm still getting a "dot" in the display. (Bug)

If I enter manual mode and then go back into preset mode there is no "dot." (seems ok)

image-et-son commented 2 years ago

That's one stubborn bug. I fixed it but then I needed to change something very close by...

el-folie commented 2 years ago

Can confirm Matrix12x´ description.

el-folie commented 2 years ago

alpha 13.4 1, The dot when booting in preset mode seems to be gone here. Booted a few times in panel/preset mode. Confirmed.

  1. The dot randomly appearing when entering preset mode is still happening. No pattern to it.
matrix12x commented 2 years ago

I confirm correct behavior and that the dot is not there