search

imchipwood / dumbpad

Simple 4x4 numpad with rotary encoder. Powered by QMK via ATmega32u4 Pro Micro
GNU General Public License v2.0
373 stars 57 forks source link

Led question from a newbie #40

Closed cgdsyldrm closed 11 months ago

cgdsyldrm commented 11 months ago

Hello, first and foremost thank you for sharing this beautiful macropad. I tried to find my answer another other issues but I couldn't.

So I am a new to this, both building a custom macropads and soldering but I'm getting there. Is it possible to add those circular led as in the photos? If so, do I need to solder them with a resistor or something? Also do I need to do something with the code?

1695988325281 1695988325287

imchipwood commented 11 months ago

I can't tell which board you're using but none of the boards are set up to use thru-hole LEDs in that way - the routing is very difficult on 2-layer PCBs, and since there's an RGB LED version available, I've never bothered to attempt the routing.

cgdsyldrm commented 11 months ago

Hello @imchipwood, the board is oled version, I see and thank you for the clarification.