Yeah, I think I've noticed the same thing. I was told by the klipper guys
that is was not necessary, but perhaps that only applies to Fluidd and
MainSail then. I'll add it back. Thanks!
tir. 4. jun. 2024, 00:58 skrev IfOnlyItWasThatEasy @.***
I just realized that removing the gcode_ids in lines 309, 327, and 341
break the outputs at the top of the Octoprint window. I recommend leaving
them in. I'm not sure where the gcode_id in line 317 is used at.
Yeah, I think I've noticed the same thing. I was told by the klipper guys that is was not necessary, but perhaps that only applies to Fluidd and MainSail then. I'll add it back. Thanks!
tir. 4. jun. 2024, 00:58 skrev IfOnlyItWasThatEasy @.***