Closed eliasbakken closed 2 years ago
I've managed to reproduce the noise produced by steppers by setting them in spreadcycle mode. This can be enabled by adding the following line to the Klipper config:
[tmc2209 <stepper_name>]
stealthchop_threshold: 0
Jon will mail the board in question, pushing issue to next software version.
This was a problem with one board that failed to connect to the stepper drivers. The board has been returned. I'm closing this issue.
It has been reported that there is at least one instance of noisy stepper motors when used with Recore. The steppers are from a Creality Ender 5 Pro. Further investigations is are needed to reproduce this problem.