Open cdeister opened 6 years ago
Might be related, the Fan pwm driver runs at 1khz. Can this be changed out of audible range? 20khz+? I know some fans don't run at this high of frequency even at 100% duty but every 50mm blower fan I throw on this thing is louder than the rest of the printer, even at 0.10a. I'd like to use a 0.24a fan without a whine.
Related to discussion on G+ some time ago: https://plus.google.com/105486978634901788220/posts/R7nkDC4WAQP
I've noticed a resonance with some heater wire that results in a buzz when the board is under high(ish) load. Switch the heaters to on/off mode works, but I think tweaking the PWM frequency a bit would be ideal. On the discussion Elias mentions that manipulating the files themselves will affect the DAC, so perhaps a cfg approach is best?