Wiring has a very misleading pictorial. Top of the first page. From the X-axis
assembly, it shows the Drag Chain going off to the right, looping down, going across
the front of the gantry, diving down on the left to the inside of the left Y extrusion,
moving towards the front of the machine, moving up, across the top of the Y
extrusion and into the controller. Of course, this is completely false.
May I suggest a view from the back left of the X-Carve instead of the front right? You
could then show the two Drag Chains, and the actual wire routing. A top view would
be helpful too. I do like the pictorial-like picture with the orange and red cables.
They just don’t represent the actual path of the wiring.
Can resolve by adding a "rear view" of the X-Carve wiring illustration image. Alternatively, could replace the current image completely.
Wiring has a very misleading pictorial. Top of the first page. From the X-axis assembly, it shows the Drag Chain going off to the right, looping down, going across the front of the gantry, diving down on the left to the inside of the left Y extrusion, moving towards the front of the machine, moving up, across the top of the Y extrusion and into the controller. Of course, this is completely false.
May I suggest a view from the back left of the X-Carve instead of the front right? You could then show the two Drag Chains, and the actual wire routing. A top view would be helpful too. I do like the pictorial-like picture with the orange and red cables. They just don’t represent the actual path of the wiring.
Can resolve by adding a "rear view" of the X-Carve wiring illustration image. Alternatively, could replace the current image completely.