wvc300 inverter is showing a limit setting of 201W should be 250W for the WVC300

invite-frey / wvc-inverter

WVC Inverter Control Flow for Node Red

MIT License

12 stars 4 forks source link

wvc300 inverter is showing a limit setting of 201W should be 250W for the WVC300 #5

Closed dlarue closed 3 years ago

dlarue commented 3 years ago

Any ideas on why this limit is showing in the display? I've run the KDM software and verified the limit is set to 100% and that should be 250W. I've seen more than 200W from the inverter since it's a 285W panel connected.

wvc-inverter-dashboard-WVCInverterControl

dlarue commented 3 years ago

The limit setting may have been from eroneous data since not only did I not see any limit set when checking using the KDM application the limit setting is not blank after I've added the isNaN() check on msg.payload[0] before trying to convert to float. Ie the bogus data might have caused the limit getting set???? So far it has gone away but I will continue to monitor the monitor.