Adding phy adapter name to Gateway Info page

[spinarr]

eth0 Link encap:Ethernet HWaddr 00:07:32:3d:2e:2d inet addr:10.0.0.3 Bcast:10.0.0.255 Mask:255.255.255.0 inet6 addr: fe80::207:32ff:fe3d:2e2d/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:324330 errors:0 dropped:0 overruns:0 frame:0 TX packets:294543 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:212289345 (202.4 MiB) TX bytes:45403969 (43.3 MiB)

• eth0 can be also included
• why is on this page mac 00:00:00:00:00:00?
• supply voltage shows 2.7x V on the UP board - correct?

[spinarr]

Adding eth0 and wlan0 also before IP addresses.

IP addresses	169.254.8.96 192.168.1.141

eth0: f0:de:f1:79:19:90 wlan0: 74:e5:0b:18:6e:8a