search

j-be / AutoBim

A bed tramming utility for OctoPrint using ABL
Other
29 stars 3 forks source link

Where is the button / screen? #8

Closed HeMaN-NL closed 3 years ago

HeMaN-NL commented 3 years ago

I just installed this plugin in octopi 0.18.0 (with octoprint Version 1.6.1) on a Pi 3b+ connected to a Ender 3 v2 with Jyers firmware 1.32 with BLtouch and UBL.

In Octopi I did not see the plugin in the repository list, so I installed it by url as instructed in the readme. I can see it installed; in the settings I can see AutoBim under the plugins. In the settings I enabled "show button in Navbar and restarted the Pi (all AutoBim sttings see below).

However, there is no button in the UI I can see, where is it supposed to be visible? In the settings page - plugins AutoBim I can "Start AutoBim"and my printer start probing the four corners. The result of a probe is only visible in the "Printer Notifications"section of Octopi.

Is there anything I did miss or must change for the AutoBim button / UI to be visible?

AutoBim settings I have are:
invert arrows : off
Multipass: on
Accuracy 0.02
UBL: on
points: all default
show button in navbar: on
HeMaN-NL commented 3 years ago

sorry, just found it; I did not notice the (blue) button at the top. I also had to install some plugins to send messages to the display aparently, installed those and now I completed a first bed level with autobim

j-be commented 3 years ago

Hey, that was faster then I was able to react :smile:

I also had to install some plugins

I presume that is due to Creality doing LCD different from everybody else on the V2. Could you point me to the plugins? Maybe I can implement something so the plugins aren't needed.

HeMaN-NL commented 3 years ago

https://github.com/Jyers/Marlin/wiki/OctoPrint-Settings

I think it was M73 progress plugin that did the trick, but I installed all other plugins mentioned as well