search

j4s0n-c / trowaSoft-VCV

trowaSoft Modules for VCV Rack
Other
105 stars 17 forks source link

FEATURE REQUEST - voltSeq: another default voltages/notes #15

Closed DomiKamu closed 6 years ago

DomiKamu commented 6 years ago

Hi again, for feature request.

For future releases, about voltSeq, is it possible, for any step, to change default to 0V (instead of -10.0V) and default notes pitched to C5 (instead of C0), assuming 0V / C5 is "middle position" (delivered voltages by the seq are bipolar -10V/+10V, I presume following "1V/octave" rule). Also I've understood voltages and notes (across modes) are linked.

Thanks (again) in advance if you'll can consider this request, for future releases of trowaSoft seqs.

Dominique.

chichian commented 6 years ago

Hi Dominique,

Sure. This is something we were thinking of changing too. We had chosen the lowest value for the "default" initially so that "Pattern" mode would default to Pattern Num 1, but it is inconvenient for the other modes. I will see if I can change the default value whenever you change the mode (so it's always a value that makes sense for that mode).

FYI: The latest version voltSeq should now use C4 = 0V (another user pointed out that Rack recommends C4 to be 0V).

Thanks for the suggestion!

DomiKamu commented 6 years ago

Excellent! I've seen C4 <=> 0V from VCV Voltage Standards, if I'm remember. ;)

chichian commented 6 years ago

Hi Dominique,

This was changed in the new 0.6 release. Thanks!

DomiKamu commented 6 years ago

Hi Jason, I've seen it, thanks! I close this issue.