Any help will be appreciated. I'm using a Microsoft LifeCam HD-3000 on my 3d printer (Creality Ender-3/V3 KE). It is a proper V4L2 device, but whatever I try, I only get a protocol error. I've been searching around, but can't seem to find info on that specific error message. See info below.
root@***** /opt/bin/mjpg_streamer -i "/opt/lib/mjpg-streamer/input_uvc.so -d /dev/video4 -r HD -f 15" -o "/opt/lib/mjpg-streamer/output_http.so -p 8088"
MJPG Streamer Version.: 2.0
i: Using V4L2 device.: /dev/video4
i: Desired Resolution: 1280 x 720
i: Frames Per Second.: 15
i: Format............: JPEG
i: TV-Norm...........: DEFAULT
UVCIOC_CTRL_ADD - Error at Pan (relative): Inappropriate ioctl for device (25)
UVCIOC_CTRL_ADD - Error at Tilt (relative): Inappropriate ioctl for device (25)
UVCIOC_CTRL_ADD - Error at Pan Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_ADD - Error at Tilt Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_ADD - Error at Pan/tilt Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_ADD - Error at Focus (absolute): Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Pan (relative): Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Tilt (relative): Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Pan Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Tilt Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Pan/tilt Reset: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Focus (absolute): Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at LED1 Mode: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at LED1 Frequency: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Disable video processing: Inappropriate ioctl for device (25)
UVCIOC_CTRL_MAP - Error at Raw bits per pixel: Inappropriate ioctl for device (25)
o: www-folder-path......: disabled
o: HTTP TCP port........: 8088
o: HTTP Listen Address..: (null)
o: username:password....: disabled
o: commands.............: enabled
libv4l2: error turning on stream: Protocol error
Unable to start capture: Protocol error
i: Can't enable video in first time
i: cleaning up resources allocated by input thread
Folks,
Any help will be appreciated. I'm using a Microsoft LifeCam HD-3000 on my 3d printer (Creality Ender-3/V3 KE). It is a proper V4L2 device, but whatever I try, I only get a protocol error. I've been searching around, but can't seem to find info on that specific error message. See info below.