I recently built the module acquired from Pushermans, once assembled I attempted to install it in my TipTop Mantis case but found that the top of the PCB is too close to the top of the front panel to be able to be screwed into the case. The rails in the case interfere with the top of the PCB around the JTag header.
I also have a case with Pulp Logic rails and the module fits those fine, thankfully this is the case I intend to installed it in, however others might not be as fortunate as me especially as this is a pretty common case. I suspect this might require a redesign of the PCB layout.
I can provide photos and measurements if this would help in resolving the issue.
I recently built the module acquired from Pushermans, once assembled I attempted to install it in my TipTop Mantis case but found that the top of the PCB is too close to the top of the front panel to be able to be screwed into the case. The rails in the case interfere with the top of the PCB around the JTag header.
I also have a case with Pulp Logic rails and the module fits those fine, thankfully this is the case I intend to installed it in, however others might not be as fortunate as me especially as this is a pretty common case. I suspect this might require a redesign of the PCB layout.
I can provide photos and measurements if this would help in resolving the issue.