Week 3 Progress Report- MediBuddy 1st Sprint

[jaredwhichard]

Progress Report

1. State the overall status of this sprint
2. Present this weeks schedule
3. Identify Tasks that have been scheduled for this week
4. Rate level of completion on a scale of 1-5, 1 meaning to task not started and 5 meaning task complete
5. Rate level of effort on a scale of 1-5, 1 meaning task was extremely difficult and will cause delay and 5 meaning task was easier to complete then planned
6. Task Debrief: (link to any completed documentation, acknowledge short comings or achievements, mention problems and revisions if necessary)

[jaredwhichard]

Progress Report

1. State the overall status of this sprint
2. Present this weeks schedule
3. Identify Tasks that have been scheduled for this week

• Dan: 3D printed finger clip

• Jared: Raspberry Pi / MAX30102

• Collaborative meeting later in the week

4. Rate level of completion on a scale of 1-5, 1 meaning to task not started and 5 meaning task complete

• Dan: 3D printed finger clip

• Jared: Raspberry Pi / MAX30102

  • 4, working with documentation, went to different code then initially planned on. uses less physical connectors, unsure of the downsides.

• Collaborative meeting later in the week

  • Completed, discussed and analyzed dependencies
    5. Rate level of effort on a scale of 1-5, 1 meaning task was extremely difficult and will cause delay and 5 meaning task was easier to complete then planned

• Jared: Raspberry Pi / MAX30102

  • 3, prior failures were discouraging with little in the way of fault logging. Current method wasn't horribly challanging however accuracy is a concern.
  • 6. Task Debrief: (link to any completed documentation, acknowledge short comings or achievements, mention problems and revisions if necessary)

• Jared: Raspberry Pi / MAX30102

  • https://github.com/jaredwhichard/Capstone-Website/wiki/MAX30102-on-Raspberry-Pi-Setup Revised this page in the wiki from last week with additional information about the physical setup and importing the code. Used Blank as my test subject for the readout.