What steps will reproduce the problem?
1.In 'setup' there is no 'current' attribute to set.
2.In Planner PID Config - MVALink there is only a 'BATT_CAPACITY" attribute.
No Power Sensor values.
3.'test' > current Reports 'Not Enabled'
What is the expected output? What do you see instead?
Expected to see: setup > current on, setup > current 2300 as in Beta 2.012
What version of the product are you using? On what operating system?
APM 2
Windows 7
Please provide any additional information below.
Original issue reported on code.google.com by stafford...@att.net on 2 May 2011 at 4:51
Original issue reported on code.google.com by
stafford...@att.net
on 2 May 2011 at 4:51