search

jcallaghan / home-assistant-config

My Home Assistant configuration & documentation.
https://www.jcallaghan.com/
MIT License
175 stars 8 forks source link

Hardware: Sonoff POWR2 #58

Closed jcallaghan closed 4 years ago

jcallaghan commented 4 years ago

image Photo Credit: Hobby Tronics

*Note the POWR2 shares the same flashing instructions as #65 but also include two additional pins.

image

  1. Solder a 6 pin connector to the Sonoff Pow R2 module.
  2. Use female-to-female jumper leads to connect the module to a USB serial UART board set at 3.3v.
  3. When connecting hold down the button (GPIO0) on the module.