Missing hole on other revision of Mainboard

jeffqchen / PS2EasyHDD

A 3D printed shell for PS2 Network Adapter that allows easy access to the hard drive.

Creative Commons Attribution Share Alike 4.0 International

122 stars 4 forks source link

Missing hole on other revision of Mainboard #2

Closed burgsth closed 7 months ago

burgsth commented 7 months ago

I have a SCPH-10350 with a BA-005 Mainboard which lacks of the mounting hole of your uses BA-006.

The PCB seems to fit nearly into the case, so only a other position of the hole would be needed. Only right side is slightly different.

jeffqchen commented 7 months ago

I'll add that in soon. With the two existing holes, it should be sturdy enough to use for the time being.

jeffqchen commented 7 months ago

I have moved the M3 screw position to use the hole you indicated. Please check the new files.

burgsth commented 7 months ago

The hole for the right ic needs to be slightly larger

jeffqchen commented 7 months ago

The two holes are of the same size. However since it's on a precarious location, it might end up being printed crooked. You can widen it by shoving the M3 hex screw driver bit into it and twist a few times.

burgsth commented 7 months ago

Sorry, I ment the VS32AH hole. I've marked the part red.

IMG_3768 (1)

On the other part, there are some condensators which need a change in the cover to fit. (marked black)

jeffqchen commented 7 months ago

Did fixes according to your info. Please check the updated pieces.

burgsth commented 7 months ago

Fits nearly perfect, except there ist only a round hole on my pcb and it seems there is a long hole on yours on the right side in the middle of the pcb. Cut it and and it fitted perfect. Will continue assembling and report any further informations.

jeffqchen commented 7 months ago

Thanks. I've removed that stub. It only exists on the newer rev.

burgsth commented 7 months ago

Assembles fine now without flaws, thank you very very much for your help! Only thing maybe is to make the holes for screw heads slightly larger, I need to get screws with smaller heads.

I have some more slim and fat adapters. If you are interessted I can take a look at the mainboard revision and testprint your designs to verify.

jeffqchen commented 7 months ago

Thank you for your help. I'm still working on the 10281 for now and it will be available as soon as it's verified by me personally. Hopefully all the fixes you suggested were already put in it. Thank you for all your help!