search

jfedor2 / flatbox

Low profile hitbox-layout fightstick
662 stars 135 forks source link

3D Printing Question #15

Closed LuminarySC closed 2 years ago

LuminarySC commented 2 years ago

Hi,

Just a quick question about 3D printing the case. Did you opt for 100% infil on the print or did you find a lower infill % was good enough?

Many thanks,

Lumi

jfedor2 commented 2 years ago

Hi,

High infill is not necessary. I used whatever the default was in my slicer profile (15% I think).

LuminarySC commented 2 years ago

Hi that's great, thank you very much. Can't wait to get this all set up