Rev3 PCB Pin Header Sizes Not Listed

jfedor2 / flatbox

Low profile hitbox-layout fightstick

662 stars 135 forks source link

Rev3 PCB Pin Header Sizes Not Listed #40

Closed Styggy closed 1 year ago

Styggy commented 1 year ago

Hi, I've tried my best to find which pins are appropriate for soldering as the standard pins I'd use for an Arduino don't want to fit into the Rev3 board and it's not listed anywhere in the documentation.

I'm assuming a 2.5mm pitch with a .5mm pin would be small enough but I just want to be sure before I proceed, thank you. The standard size pins fit the brook PCB but not the custom PCB itself.

jfedor2 commented 1 year ago

Pitch is 2.0mm. When you say the pins don't fit the PCB, do you mean that a single pin won't go through the hole? I think the ones I used were 0.5mm.

Styggy commented 1 year ago

Yeah they won't go through, that's what I needed though, thanks for the quick response.