search

jfedor2 / flatbox

Low profile hitbox-layout fightstick
672 stars 136 forks source link

Consider RP2040-Zero variant #8

Closed JonnyHaystack closed 1 year ago

JonnyHaystack commented 2 years ago

I've just seen this tiny Pico alternative https://www.aliexpress.com/item/1005003504006451.html which looks like it should be easy to design around and would allow for a much cheaper non-SMD RP2040 version of the flatbox. It has a variant that comes with pin headers as well, which would make the soldering really easy because if you had holes for all the pins on your PCB the builder would only have to solder on one side. Also it has USB C!

jfedor2 commented 1 year ago

An RP2040-Zero based rev5 is now released!

d75cce5

TheTrainGoes commented 1 year ago

@mytokat84 with a 0.96" OLED screen added you would need to adjust the pinout to ensure a good I2C pair.

With the current setup you would be limited to choosing either OLED or RGB but not both as you would be short one pin.

There are additional pads on the back of the Zero you could use for this but they are a pain to tap into.

TheTrainGoes commented 1 year ago

@mytokat84 you can replace L3 and R3 with an OLED if you like. I would need to check the pins and make sure they can be used as a proper pair for the I2C line. You would also need to add two resistors on the SDA and SCL lines (I use 4.7k).

For the RGB line you need to to have a 5v logic shifter on the data line (move from 3.3v to 5v). You will also need a cap and a resistor (100nF and 10k).